Probuilder 69366 Manual De Instrucciones página 53

There is a risk of bursting if the tool is
damaged.
Check for misalignment or binding of
moving parts, breakage of parts and any
other condition that aff ects the tool's
operation. If damaged, have the tool serviced
before using.
Use only accessories identi� ed by the
manufacturer to be used with speci� c tools.
Use of an accessory not intended for use with
the speci� c tools increase the risk of injury to
persons.
WARNING! RISK OF ELECTRIC
SHOCK
Using air tools to attach electrical wiring can
result in electrocution or death.
Never use nail/staplers to attach electrical
wiring while energized.
This tool is not provided with an insulated
gripping surface. Contact with a "live" wire
will also make exposed metal parts of the
tool "live" and can result in electrocution or
death.
Avoid body contact with grounded surfaces
such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is grounded.
Fasteners coming in contact with hidden
electrical wiring could cause electrocution or
death.
Thoroughly investigate the workpiece for
possible hidden wiring before performing
work.
WARNING! RISK OF ENTANGLEMENT
Tools which contain moving elements, or
drive other moving parts, such as grinding
wheels, sockets, sanding discs, etc., can
become entangled in hair, clothing, jewelry
and other loose objects, resulting in severe
injury.
Never wear loose � tting clothes or apparel
that contains loose straps or ties, etc., which
could become entangled in moving parts of
the tools.
Remove any jewelry, watches, identi� cations,
bracelets, necklaces, etc., which might
become caught by the tool.
Keep hands away from moving parts. Tie up
or cover long hair.
Always wear proper � tting clothing and
other safety equipment when using the tool.
WARNING! RISK OF CUT OR
BURNS
Tools that cut, shear, drill, staple, punch,
chisel, etc. are capable of causing serious
injury.
Keep the working part of the tool away from
hands and body.
WARNINGS!
Replace warning labels if they become
obscured or removed.
Do not use this tool for other than its
intended use.
Excessive air pressure or too much free
rotation will decrease the life of the tool
and may cause a hazardous situation.
Check air hose for wear, and keep them
away from heat and sharp edges.
Do not carry the tool by the air hose.
Slip / trip / fall is a major cause of serious
injury or even death. Be aware of excess
hose left on your walking way or on the
working surface and be aware of the
whipping air hose too.
Continuous operation and bad working
condition will injure hands. Once hand
numbs or aches, operator shall stop the
tool for a while for relaxing and re-start
the work after recovery. Operator shall
immediately see a doctor if such a serious
symptom occurs.
GB
53