Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
MAINTENANCE
VALVE DISASSEMBLY
To reassembly the valve, proceed as follows:
1. Place the plunger (8) into its housing in the valve body (7).
Then place the spring (9) in the plunger (8).
2. Place the assembly mounted in step 1 in the control
valve body (6) and screw the valve body (7) by hand a
few turns. Take special care during assembly that the
spring end (9) is placed into its housing in the control
valve body.
3. Place the control valve body (6) in a vise or similar, and
tighten the valve body (7).
4. Assembly the trigger (5) and then place the pin (4).
5. Assembly the trigger guard (1) tightening the screws
(2) y (3).
7 7 7
7
STRAINER DISASSEMBLY
1. Verify that there is no pressure in the fluid line.
2. Disconnect the hose from the swivel (1) by loosening the fitting (2) of the hose.
3. Remove the o-ring (3) and then remove the strainer (4).
4. Proceed to clean or replace the strain depending on the cose.
5. Reassemble the strain (4) in the swivel (1) and fix it.
6. Mount the hose.
2
6
836 837 R. 09/20
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
8 8
8
8
1
9
9 9
9
1
1
6
2
2
4 4
4
4
3
3
4
4 4 4
5 5
5
5
3
3
Publicidad
Tabla de contenido
