Electrolux DFW51 Manual De Instrucciones página 11

Electronic Control of Freezer Tempe-
rature
By touching the button succes-
sively, you can select the freezer
temperature.
Electronic Control of Freezer
Temperature
(default temperatures)
Freezer Temperature
Adjust
Maximum -20,5ºC (cold maximum)
Medium -18ºC (cold medium)
Minimum -15,5ºC (cold minimal)
The internal temperatures may vary depending
on the room temperature, charging, number of
opening of the doors and ventilation of the place
where the product was installed.
The positions of temperature adjustment of the
freezer are pre-established at the factory. But this
temperature depends on the conditions of packa-
ging of the food and the frequency of opening of
the door. So, take care to place the food in a way
they do not obstruct the air exits and avoid to open
the door unnecessarily.
The refrigerator compartment has an independent
temperature control located in its interior, close
to the lamps. To regulate it, refer to the section
"Manual Temperature Control of the Fridge".
Fine Adjustment of Freezer Temperature
Your refrigerator was produced within the interna-
tional standards and has three levels of temperatu-
re with pre-established values at the factory, which
can be adjusted (reduced or increased) according
to the necessity.
If you want to change it, there is the possibility of
the Fine Adjustment of Temperature with three
levels, as explained next.
To program this function:
1. Press the "AUTO CONTROL" button and se-
lect the VACATION function, and then press
the "TEMP FREEZER" button 5 times. The
functions indicator will be turned on, indicating
the last adjustment. The fine adjustment of tem-
perature programmed is valid for the 3 levels
of temperature of the freezer compartment.
---
---
2. Setting Options:
To increase 0,5 ºC in the pre-established tempera-
ture, press the TEMP. FREEZER BUTTON until
it shows 05 in the Functions indicator.
To increase 1 ºC in the pre-established tempera-
ture, press the TEMP FREEZER button until it
shows 10 in the Functions indicator.
To reduce 0,5 ºC in the pre-established tempera-
ture, press the TEMP FREEZER button until
it shows 05 with a dash on the left side of the
Functions indicator.
To reduce 1 ºC in the pre-established tempera-
ture, press the TEMP FREEZER button until
it shows 10 with a dash on the left side of the
Functions indicator.
To reduce 2,0 ºC in the pre-established tempera-
ture, press the TEMP FREEZER button until
it shows 20 with a dash on the left side of the
Functions indicator.
After three seconds without pressing any button,
the fine adjustment is finalized.
To verify what is the last adjustment realized:
Press the "AUTO CONTROL" button and select
the VACATION function and then press the TEMP
FREEZER button 5 times. The Functions indicator
will turn on, indicating the last adjustment.
11