Light Replacement - Electrolux DFW51 Manual De Instrucciones

3. Leave it in a clean water container for three hours.
4. Remove and leave the deodorizer at rest to dry for
3 hours and assemble it again.
5. The deodorizer should be changed after its third
cleaning.
6. It is recommended the use of a small screwdriver to
remove the part supporting the deodorizer.
Cleaning of the Water Collector
Your refrigerator has a water
collector located in the back
part, near the compressor (engi-
ne). The function of the collector
is to store the water from the
automatic defrost that evaporates through the
heat generated in that region.
The cleaning of the collector is not necessary
for the functioning of the refrigerator. If you want
to clean it, turn the refrigerator off of the electric
Power, removing the plug of the socket and use
a wet cloth.
WARNING
Do not remove the collector when cleaning
it, and do not displace the tubes located
inside this colector. Do not throw water
directly inside or outside the refrigerator.
External part
In order to easily clean the exter-
nal part of your refrigerator, use
a humid cloth in a warm water
solution with neutral soap and
then dry it carefully.
(Only for the DW51X model)
The doors have a special protector varnish, which
avoid fingerprints and marks.
Use a dry flannel or dip it in warm water with mild
soap and then dry it carefully.
ATTENTION
As the special varnish is applied in your
product to ease the cleaning, do not use
abrasive sponges, steel, brushes, or even
products that are special to clean stain-
less steel, pastes, sapolio and products
with inflammable fluids, such as alcohol,
kerosene, gas, varsol, solvents, automotive
waxes, polishers or other abrasive chemi-
cal products such as chlorine, detergents,
acids or vinegars. The use of such prod-
ucts may damage the polish protection
and, consequently, result in irreversible
scratches and/or marks on the surface of
your refrigerator.
We recommend you to activate the LOCKED
ELECTRONIC PANEL function when execut-
ing the cleaning of the Control Panel to
avoid accidentally activating some func-
tion.
ATTENTION
The doors rubbers are attached and
removable.
Door Rubber Seal
The sealing rubbers of the doors may be cleaned
carefully with a wet cloth, avoiding damaging
them.

Light Replacement

To replace the light of your Refrigerator, proceed
in the following manner:
Refrigerator Compartment:
1. Turn the refrigerator off of the
electric power.
2. Press the inferior part of the
cover upwards, displace it fron-
twards and remove it.
3. Change the burnt light for ano-
ther with the same dimensions,
tension and maximum power of
15 W.
Freezer Compartment:
1. Turn the refrigerator off of the
electric power.
2. Remove the superior freezer
shelf.
3. Open the cover of the light pres-
sing the lock with a screwdriver.
4. Change the burnt light for ano-
ther with the same dimensions, ten-
sion and maximum power of 15 W.
13