Labelmate CAT-3 Manual Del Usuario página 6

EXTERNAL HALT CONTROL (FIG.4) :
• An External Halt Control jack on the CAT-3 is for use with external devices capable of providing an open circuit halt
command. A 3.5mm control cable is necessary for use (not included).
• With Pin 2 and Pin 3 of the External Halt Control circuit closed (connected together using a 3.5mm dual circuit plug), the
CAT-3 will operate. When the External Circuit is opened, the CAT-3 will stop.
• 3.5mm "EXTERNAL HALT CONTROL" Stereo Plug (Dual Circuit Plug)
• Contact CLOSED=RUN
• Contact OPEN=HALT
• Pin 1 - No connection (NOT USED)
• Pin 2 - Normally Closed (NC) contact
• Pin 3 - Normally Closed (NC) contact return
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions