Connecting A Dvd Player With A/V Connectors - Sony Wega KZ-32TS1 Manual De Instrucciones

Connecting a DVD Player with A/V Connectors

Use this hookup if:
• Your DVD player does not have component (Y, P
Tip
If your DVD player has video component output connectors: for best picture quality use the
connection described on page 12.
Disconnect all power sources before making any connections.
1
Using an AUDIO cable, connect the DVD player's AUDIO OUT jacks to
the TV's AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player's S VIDEO jack to
the TV's S VIDEO jack.
Rear of TV
VIDEO IN 1
R AUDIO L VIDEO
VIDEO IN 2
AUDIO-R (red)
AUDIO-L (white)
RK-74A
(not supplied)
DVD player
Tips
• To take advantage of the Wide Screen Modes, set the TV's aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Use VIDEO on the remote to switch between the VCR and DVD player inputs. Use 0-9 and
ENTER or CH +/– on the remote to watch cable TV.
• If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
Installing and Connecting the TV
COMPONENT VIDEO IN 1 AUDIO OUT
S VIDEO R AUDIO L Y P P R
B R
Y/G P /B P /R
R AUDIO L HD
B R
COMPONENT VIDEO IN 2 / RGB IN
S VIDEO
YC-15V/30V
(not supplied)
, P ) jacks.
B R
VHF/UHF
L
AC IN
CONTROL
IN
S
VD
OUT
SUB
WOOFER
(US)
US
13