Sony Wega KZ-32TS1 Manual De Instrucciones página 57

Problem
No sound./Noisy sound.
Good picture, no sound.
Audio noise.
Cannot operate the menu.
Wide Screen Mode changes
automatically.
Wide Screen Mode changes
automatically while Auto
Wide is set to on.
Strange sound.
The TV cabinet creaks.
The TV whirs.
The TV ticks.
The TV buzzes.
Remote control does not
operate.
Possible remedies
• Check the volume control.
• Press MUTING or VOL + so that "Muting" disappears from the screen (page 20).
• Disconnect your headphones.
• Set "Speaker" to "On" in the
sound is not output from the TV's speakers regardless of the TV's volume control.
• Make sure that the antenna is connected using the supplied 75-ohm coaxial cable.
• Keep the antenna cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
• Press MTS/SAP to select "MONO" (page 40).
• If the item you want to select appears in a pale color, you cannot select it.
• The picture size may change when the program has commercial breaks, because the TV
selects the best Wide Screen Mode automatically for each program (See page 26).
• The TV receives the picture with control signal and selects the best Wide Screen Mode
automatically to fit the wide screen (See page 26).
• When you change the channel or input, the TV selects the best Wide Screen Mode
automatically. If you want to fix the Wide Screen Mode selected with the WIDE MODE
button, set "Auto Wide" to "Off" in the
• Changes in room temperature sometimes causes the TV cabinet to expand or contract,
which can make slight noises. This does not indicate a malfunction.
• The TV's fan setting is working. This does not indicate a malfunction.
• An electrical circuit inside the TV is activated when the TV is turned on. This does not
indicate a malfunction.
• There might be a surge sound when turning on the TV. This does not indicate a
malfunction.
• The batteries could be weak. Replace the batteries.
• Check the polarity of the batteries.
• If the STANDBY/SLEEP indicator on the TV does not light in red, press POWER on the
TV.
• Point the remote control at the remote control sensor of the TV.
• Install the TV away from fluorescent lights.
(Custom Setup) menu (page 11). If it is set to "Off,"
(Screen Control) menu (page 28).
Additional Information
US
57
(US)