Installation And Connection - Oase InScenio 230 Instrucciones De Uso

Symbols on the unit

Installation and connection

Installing the unit
 B, C
WARNING
The unit is subject to dangerous voltage and must not be installed directly adjacent to the water.
Otherwise there is a risk of severe injuries or death by electrocution.
 Install the unit at a distance of at least 2 m from the water to ensure that it is protected
against flooding.
Connecting the power supply
 D
Unit version with power plug:
• Push the coupling of the power cable onto the unit plug.
Unit version with power cable (version only for the United Kingdom):
• Only allow qualified electricians to perform work on the power supply.
• Adhere to the pin assignment specified on the power cable label. Note the warning on the
power cable.
• Only use wires with wire end ferrules.
Connect the units to the power supply distributor
 E
NOTE
 Ensure that the total outlet output of 16 A (2700 W) is not exceeded. Otherwise the unit will be
damaged.
Never connect a transformer to the outlet with the dimmer function. Otherwise the unit will

be damaged.
• Fasten the power cables of the connected units to the installed strain relief.
The unit is protected against the ingress of splash water.
Protect the unit from direct sunlight.
Do not dispose of the unit with normal household waste.
Read the operating instructions.
EN
9