Pod Location & Wire Routing - Kicker KSMT25 Manual Del Propietário

Pod Location & Wire Routing
Route the wiring loosely through the Washer and
Wing Nut, as these will be secured at the end of
installation. It is best to securely wire the crossover
within an enclosed location. Make sure that the
crossover will not be exposed to water. If installing the
crossover in the door, keep it high and shielded from
water. Exercise caution as water can accumulate in
the bottom of the door.
rubber grommets
If factory speaker wiring is not available in your desired
location, it may be necessary to run speaker wire
through the door jamb. The speaker wire should be
kept away from sharp edges and avoid the possibility
of getting pinched by the door. An existing grommet
in the door jamb is the ideal place to run the speaker
wire. If the factory hole and grommet do not exist
or are inaccessible, you must drill a hole to run the
speaker wire through the door jamb. Be careful not
to drill into other wiring or existing door mechanisms.
Any time a wire is run through a hole, it is necessary
to insert a rubber or plastic grommet to protect the
wire from damage.
English
possible pod
mounting locations
from amplifier or source unit
8