Nikon PC-E NIKKOR 24mm f/3.5D ED Manual Del Usuario página 23

Important!
• When the lens is mounted to a camera other than the D3, shift,
tilt and/or revolve the lens with care. Failure to do so, may result
in the lens scratching the camera body.
• This lens is a manual focus lens, and autofocus is not possible
even when the camera's focus mode is set to AF mode.
• Use of tilt/shift function can cause some vignetting or slight color
change. (Vignetting is the darkening of the corners around the image.)
• When mounted on Nikon digital SLR (Nikon DX format) cameras,
such as the D2-Series and D300, the lens' picture angle becomes
61° and its 35 mm equivalent focal length is approx. 36 mm.
• Be careful not to soil or damage the CPU contacts.
• If the lens mount rubber gasket is damaged, be sure to visit your
nearest Nikon authorized dealer or service center for repair.
• In low temperatures, new or fully charged batteries should be
used in the camera.
4. Mounting lens
a
Set the shift amount and tilt amount to 0 by rotating the shift
and tilt knobs (Fig. 2).
Note: Avoid attaching/detaching the lens to/from the camera
while using tilt, shift and/or revolving, and without locking
each knob. Failure to do so can lead to you pinching your
fingers between the lens and the camera body, or the lens
scratching the camera body.
b
Set the tilt and shift knobs. (Fig. 3)
Note: Turning either knob too tightly may damage the knob.
Fig. 2
Fig. 3
En
23