Software Download - Bresser 7004040 Manual De Instrucciones

SOFTWARE DOWNLOAD:

www.bresser.de/download/7004040
The software allows you to save and display your recor-
ded data. Install the software by following the setup
instructions and then start the software. Now connect
the device via the micro USB cable to your computer and
click on the USB icon [
the connection.
When you click on „Set Time" the current time will auto-
matically sync and set on the device.
RECORDING AND RECEIVING DATA
Click on „Set Param" to enter the settings menu and set
parameters as appropriate.
Here you can choose two ways to record the data:
Method 1: Immediately
Method 2: Manual
12
] in the software to establish
Method 1: Immediately
This method is used when you record data while the
device is connected to your computer.
Choose the number of records and set an Interval.
Then choose „Immediately" and click on „OK" to begin
recording. „REC" flashes on the display. The flashing
frequency is the same as the record interval, indicating
that measurement of the instrument is carried out. The
data received can only be checked once the recording is
done. Click on „Stop Recording" and then click on „Data
Download" to save the recorded data. You can now open
the saved data file to see your recordings.
Method 2: Manual
This method allows you to take the device to a location,
record the data there, and then go back to your compu-
ter to download the recorded data from the device.
First connect the device to a computer and establish the
connection. Then click on „Set Param" to enter the settings
menu and set parameters as appropriate. Then choose
„Manual" and click on „OK". Unplug the device from the
computer and take it to the location where you want to
record the data. Press the „REC" button to start recording.