Technical Data; Permissible Loads; Operating Conditions; Tightening Torques - Hymer 21000008 Instrucciones De Funcionamiento Originales

4 TECHNICAL DATA

4.1 Permissible loads

The following maximum permissible loads (incl.
the weight of personnel, tools and materials)
apply to this product:
Per step
Platform
Guardrail load
Overhanging platforms
Total load

4.2 Operating conditions

Operating temperature range
Storage temperature range
Level ground

4.3 Tightening torques

The following tightening torques apply
unless otherwise specified on the relevant
supplementary documents or assembly
instructions.
Hammer head screws must always be installed
with a 90° offset.
M8
M10
M12

5 ASSEMBLING THE PRODUCT

5.1 Assembly

WARNING | Risk of injury caused by
handling heavy loads!
→ The product must be assembled by
at least two people and with the use
of appropriate tools (e.g. cranes,
lifting equipment).
→ The product is to be set up in
accordance with the included
assembly instructions.
→ Follow the instructions in the other
applicable documents when installing
accessories and add-on parts.
06 Original HYMER instructions for use | BA article no.: 21000008
→ The fasteners for the fixed installation of
products that are connected to a substrate
or a wall (e.g. by screw connection) must be
designed and provided on site and are not
included in our scope of delivery.
150 kg

6 OPERATION

300 kg

6.1 Brake unit

50 kg (500 N)
Before getting on a mobile product, always
150 kg
engage the brake unit on it.
300 kg
–15 °C to
+55 °C
–10 °C to
+40 °C
Deviation
→ Release the brakes before moving the product.
of ±2°
Engage the brakes again once the product is at
the next location.
→ Lift up the pedal to release the castor.
→ Push down the pedal to lock the castor in
place.

6.2 Guardrails

The products are equipped with guardrails as a fall
protection measure.
18 Nm
49 Nm
79 Nm
→ The product is fitted with corresponding
mounts for installing guardrails. The guardrails
are clamped and secured in place using screws.
→ The mounts for removable guardrails are
equipped with a clamping lever that can be
released to allow the guardrail to be detached.
→ When installing a removable guardrail, the
clamping lever must be properly tightened to
ensure the guardrail is firmly attached.
WARNING | Risk of falling!
The product can move uncontrollably if
the brakes are not applied.
→ Before getting on the product,
ensure that the brakes have been
applied.
WARNING | Risk of falling!
There is a risk of falling if appropriate fall
protection is not used.
→ Before getting on the product, check
to ensure that all guardrails have
been properly installed.
→ If there are no guardrails to prevent
falls and if there is a risk of falling,
the product must be used in
conjunction with the appropriate fall
arrest PPE.