Repair Service; Legal Regulations; Technical Features - stayer HL 11B Manual De Instrucciones

Cleaning/inspecting the strainer
Expose the strainer 13 in the machine water inlet connection
by removing the inlet connector 7. Rinse and replace. If
damaged replace. Never use the pressure washer without
the strainer or a damaged strainer.
Maintenance
Stop, remove plug from the power supply and
disconnect from water supply.
Note! To ensure long and reliable service, carry out the
following maintenance regularly.
Regularly check for obvious defects such as loose fixings,
and worn or damaged components. Check that covers
and guards are undamaged and correctly fitted. Carry out
necessary maintenance or repairs before using.
If the pressure washer should happen to fail despite the
care taken in manufacture and testing, repair should be
carried out by an authorised service agent for STAYER
garden products.
Environmental Protection
Chemicals dangerous to the environment must not be
allowed to enter the ground, ground water or ponds,
streams, etc. For the use of cleaning agents, observe
the instructions on the package and the prescribed
concentration exactly. For the cleaning of motor vehicles
the local regulations should be observed: Do not allow oil
sprayed off to enter into the ground water. Recycle raw
materials instead of waste disposal.
Disposal
It is compulsory to subject electric tools, accessories
and packaging to a recovery process that respect the
environment.
For EU countries only:
Do not throw away electric tools!
In accordance
2012/19/UE on unserviceable electric and
electronic apparatus, after its transposition into
national law, they must be collected separately
to subject them to ecologic recycling.
The right to amendment is reserved.

REPAIR SERVICE

The technical service will provide you advice regarding
questions you may have on the repair and maintenance
of your product as well as on spare parts. You may also
obtain exploded views and information on spare parts on
the internet under: info@grupostayer.com
Our team of technical advisors will be glad to guide you
regarding acquisition, application and adjustment of
products and accessories.
List of Replaceable Parts
The attached table (T1) gives checks and actions that you
can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your
service agent.
Switch off and remove plug from mains before
investigating fault.
ENGLISH
with European Directive
19

5. LEGAL REGULATIONS

TECHNICAL FEATURES

The values given are valid for nominal voltages [U] 230/240
V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and
models for specific countries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
We reserve the right to change related to technical
advance.
W = Rated input power
Q = Maximum flow
P = Maximum Pressure
2
P1 = Max. Pressure Water Supply
IP = Protection index
T1 = Water temperature
M = weight
A .= Acceleration typically evaluated in the hand/arm
hw
L = Acoustic pressure level
PA
L = Acoustic power level
WA
The noise level when working can exceed 95 dB (A).
19
es
it
gb
de
fr
p
tr
el