Additional Safety Instructions; Use And Operation - Asist AE5PD85DN Instrucciones De Uso

ADDITIONAL SAFETY INSTRUCTIONS

Please read these safety instructions carefully before
use and keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The electric jigsaw complies with the applicable
technical regulations and standards.
! Secure the cut material with clamps or a vice. This
will avoid vibrations and annoying cuts.
! Before cutting, check the material to be cut and
remove all screws, staples or nails.
! When working with a jigsaw, the protective cover
must always be fitted.
! Regularly check the attachment strength of the saw
blade.
! Do not use damaged or worn saw blades. Replace
the blunt saw blade immediately.
! Check the setting of the guide roller regularly.
! Do not start the saw while the saw blade is inserted
in the workpiece.
! Never overload the saw enough to stop the engine.
! Never try to stop the movement of the saw blade,
even when the engine is already switched off.
! The saw blade will extend very quickly. The teeth of
the leaf are very sharp. Never aim the saw at people.
! Wear a dust mask as well as goggles when perfor-
ming dusty work.
! Use of accessories not recommended by the manu-
facturer or not supplied with the product may result in
fire, electric shock, or serious injury.
! Any adjustment or modification of the device without
the authorization of our company may cause injury or
damage to the user.
- ATTENTION!
Never look directly into the laser beam and never aim
the beam at anyone. The energy of the laser beam is
extremely harmful to the eyes.
/ LASER - Class 2, wavelength 650nm, radiation
<1mW /
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION (A)
This electric jigsaw is designed for cutting wood,
metals and plastics.
1) Drive pressure
2) Power switch
3) Protective cover
4) Guide pulley
5) Saw blade
6) Base plate
7) Laser switch
8) Dust extraction outlet
9) Saw blade locking lever
10) Saw blade holder
11) Vibration frequency controller
12) Parallel guide
13) Suction attachment
14) Locking screw
15) Switch for pre-oscillation setting
16) Cable
17) Suction switch
18) Laser
19) Cutting angle
Accessories
1x parallel guide
1x dust extraction attachment
1x saw blade for steel
3x saw blade for wood
Pictograms
Pictograms on the product packaging:
a) Power supply values
b) Power consumption
c) Idle speed / number of oscillations
d) Max. depth of cut - wood

USE AND OPERATION

ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Inserting the saw blade (B)
! Always unplug the saw before replacing the saw
blade.
The saw blade holder is equipped with a lever to
secure the saw blade (9). This feature allows the saw
blade to be attached and released without the use of
tools.
Turn the saw base upwards. Turn the locking lever
(9) clockwise and hold it in this position. Insert the
saw blade into the groove in the holder (10) so that its
rear part fits into the notch in the support guide pulley.
The teeth of the saw blade must point forward. Then
release the locking lever (9).
The saw blade is firmly seated.
Check the attachment by pulling on the saw blade.
Regularly check that the sheet is firmly seated. Do not
carry out this check until the saw has been switched
49