Operation - Flymo PowerVac 3000 Instrucciones De Empleo

Aspirador/soplador de jardin
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 115
Converting unit from vacuum
use to blower use:

4. Operation

WARNING:
attached to avoid flying debris and/or impeller contact which can cause serious
injury. Always wear gloves and use eye protection to prevent rocks or debris from
being blown or ricocheting into the eyes and face which can result in blindness or
serious injury.
Cables:
Connecting the unit –
cable lock/extension cables:
22
9667594-01_9667594-62 PowerVac 3000 3000-20.960.01.indd 22
All manuals and user guides at all-guides.com
1. Stop unit and unplug the extension cord.
2. Remove the elbow tube and collection bag.
3. Remove the vacuum tubes by releasing the latch on the vacuum
inlet cover and rotating the cover until the tubes are released
from the latches of the retaining posts.
4. Close the inlet cover and make sure it is latched closed.
5. Re-install the blower tube. Refer to FITTING THE BLOWER
TUBE for instructions on how to attach this item.
NOTE: A safety switch will prevent the unit from starting if the inlet
cover is not latched closed.
Do not use the unit without the tubes or collection bag properly
Use only 1.00mm
Maximum rating:
1.00mm
2
size cable
PowerVac 3000: 3.000 W
Mains cables and extensions are available from your local
approved service centre. Only use extension cables specifically
designed for outdoor use.
Loop the extension cable
This prevents unintentional separation of the electrical connection.
Then connect it to the mains cable.
i
2
size cable up to 40 metres length maximum.
and insert it into the cable lock
i
.
o
o
19.06.15 12:38

Publicidad

Tabla de contenido
loading

Tabla de contenido