IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING (THIS
APPLIANCE)
WARNING
To reduce the risk of fi re, electric shock, or
injury:
1.
Do not allow to be used as a toy. Close attention
is necessary when used by or near children.
2.
Use only as described in this manual. Use only
manufacturer's recommended attachments.
3.
Do not use work light in explosive atmospheres,
such as in the presence of fl ammable or
combustible liquids, gasses or dust.
4.
Be careful of electrical shock.
5.
When not in use or during inspection and
maintenance, be sure to turn the switch OFF
on the unit, and remove the battery from it.
6.
Do not cover the work light with cloth,
cardboards or other materials when the light
is on. Keep the light and the object being
illuminated at least 20 cm apart. Failure to
observe these warnings may result in fi re.
7.
When the light is turned on, do not look directly
into it, point it at people or animals, or aim it
toward the eyes.
8.
The LED cover will remain at a high temperature
when lit and immediately after use, so do not
touch it.
9.
Do not use, leave, or store the work light in the
rain or in humid places.
10. Do not leave the work light in a car or the like
that tends to be exposed to be searching heat
of the sun (above 122°F (50°C)). Otherwise,
troubles can result.
11. Do not leave the work light unattended while it
is turned on.
12. When placing the work light in a high location
for use, ensure that the location is stable.
Additionally, secure it in place with string, etc.
to prevent it from falling.
If it falls, it may result in injury or damage.
13. Do not use the work light if the LED cover is
damaged or detached.
14. Do not charge the unit outdoors.
15. Use only the charger supplied by the
manufacturer to recharge.
16. Do not incinerate the appliance even if it is
severely damaged. The batteries can explode
in a fi re.
GENERAL SAFETY RULES
SAVE THESE
INSTRUCTIONS
1) Work area safety
a) Keep work area clean.
Cluttered areas invite accidents.
b) Do not operate work light in explosive
atmospheres, such as in the presence
of fl ammable liquids, gases or dust.
2)
Electrical safety
a) Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
b) Do not expose work light to wet
conditions.
Water entering a work light will increase the
risk of electric shock.
3)
Personal safety
a) Stay alert, watch what you are doing
and use common sense when use work
light.
English
3