IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING (THIS
APPLIANCE)
WARNING
To reduce the risk of fi re, electric shock, or
injury:
1.
Use only the AC cord that is included with this
product.
Additionally, this AC cord is only for use with
this product. Do not use this AC cord with other
products.
2.
Use only the specifi ed power supply voltage.
3.
Do not touch the power plug (AC cord) with wet
hands.
4.
Avoid damaging the AC cord.
Do not modify, forcibly bend, twist or pull the
AC cord, place heavy objects on it or place it
near heating appliances.
5.
Insert the power plug (AC cord) securely as far
as it will go.
Dust or dirt between the power plug and the
electric socket may lead to fi re. Remove the
power plug periodically and wipe off any dust
or dirt with a dry cloth.
6.
Do not allow to be used as a toy. Close attention
is necessary when used by or near children.
7.
Use only as described in this manual. Use only
manufacturer's recommended attachments.
8.
Do not use work light in explosive atmospheres,
such as in the presence of fl ammable or
combustible liquids, gasses or dust.
9.
Be careful of electrical shock.
10. When not using the work light, or when
inspecting it or performing maintenance on it,
be sure to turn the switch OFF on the unit, and
detach the AC cord and battery.
11. Do not cover the work light with cloth,
cardboards or other materials when the light
is on. Keep the light and the object being
illuminated at least 50 cm apart. Failure to
observe these warnings may result in fi re.
12. When the light is turned on, do not look directly
into it, point it at people or animals, or aim it
toward the eyes.
13. The LED cover will remain at a high temperature
when lit and immediately after use, so do not
touch it.
14. Do not use, leave, or store the work light in the
rain or in humid places.
15. Do not leave the work light in a car or the like
that tends to be exposed to be searching heat
of the sun (above 122°F (50°C)). Otherwise,
troubles can result.
16. Do not leave the work light unattended while it
is turned on.
17. When placing the work light in a high location
for use, ensure that the location is stable.
Additionally, secure it in place with string, etc.
to prevent it from falling.
If it falls, it may result in injury or damage.
18. Do not use the work light if the LED cover is
damaged or detached.
19. Do not charge the unit outdoors.
20. Use only the charger supplied by the
manufacturer to recharge.
21. Do not incinerate the appliance even if it is
severely damaged. The batteries can explode
in a fi re.
22. Do not disassemble or modify the work light.
GENERAL SAFETY RULES
SAVE THESE
INSTRUCTIONS
1) Work area safety
a) Keep work area clean.
Cluttered areas invite accidents.
b) Do not operate work light in explosive
atmospheres, such as in the presence
of fl ammable liquids, gases or dust.
English
3