Makita XSL05 Manual De Instrucciones página 24

1
► 1 . Vise
5. Install the battery cartridge to the tool and turn on
the laser switch.
6.
Loosen the adjusting screw. To move the laser line
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
1
4
► 1 . Adjusting screw 2. Range adjustment screw
3. Hex wrench 4. Laser line 5. Saw blade
2
3
5
24 ENGLISH
Adjusting the laser line on the right side of the
blade
1
4
► 1 . Range adjustment screw 2. Hex wrench 3. Laser
line 4. Saw blade
7.
Slide the adjusting screw to the position that the
laser line comes onto the cutting line and then tighten.
NOTE: The movable range of laser line is factory
adjusted within 1 mm (0.04") from the side surface
of blade.
Cleaning the laser light lens
The laser light becomes hard to see as the lens for
the laser light gets dirty. Clean the lens for laser light
periodically.
Remove the battery cartridge. Loosen the screw and
pull out the lens. Clean the lens gently with a damp soft
cloth.
► 1 . Screw
2
3
1