Technical Data; Tools Needed For Assembly - Hortensus HOR-MANTER250 Manual De Usuario

When extended, various forces, including wind and rain, will affect an awning. These
sometimes substantial forces must be absorbed by the awning and transferred to
the assembled structure via its mounting brackets. Under extreme loads, excessive
attractive force can be exerted on the anchor bolts. Therefore, before starting
assembly, check the load-bearing capacity of the mounting base and if
necessary take corresponding measures to ensure stable installation of the
brackets. If the mounting base is unstable, you may wish to consult a specialist in
your vicinity.
The awnings are intended as a protection against the sun only. It is not to
be used during periods of strong wind, rain, hail, or snow. In case of such
conditions, retract the awning immediately.

Technical Data:

Model
Fabric dimension (mm)
Adjusting angle
Gear ratio
Wind resistance
Recommended tilting angle
Preparation
Carefully remove the awning from the box and remove the styrofoam protectors from the
awning. Remove the plastic bags and plastic guards from the awning and carefully place
the awning aside to avoid having it damaged by scratches or otherwise damaged or
soiled during assembly. Check the number of parts in the packaging whether the packing
list requirements, the quality of parts availability issues, if questions, please contact the
supplier.
Be aware the sudden extension may occur during unpacking.

Tools needed for assembly:

Drill
Masonry drill bit, 14 mm
Level
Wrench 14mm、17mm and 19mm
3.95x3m
3830 X 2950
3830 X 2950
Min. 14º to the horizon in case of rain
Stepladder
Tape measure
Chalk or marker pen
Wooden hammer
2.95x2.5m
3830 X 2950
5-45
1:7
Class 1
2.5x2m