Hortensus HOR-MANTER250 Manual De Usuario página 68

Step 5: Fixing the brackets
Place the bracket on the screw protruding from the wall. Then add flat washer and spring
washer and fix the bracket with lock nuts. Tighten them well.
It is also possible to fix the awning under a concrete ceiling. If you want to fix the awning
under a concrete ceiling you must consult a professional expert for this kind of mounting.
Drawing 5:
Bracket has been prepared to be fixed on a wall. Chose the whole you need to fix them
according to drawing.
Firmly tighten the bolts with a 17mm wrench: it is best to use a wrench with a closed
end rather than an open end because this will avoid damage to the nut if it should slip.
As soon as they are fully inserted, the brackets must sit firmly in the wall. If they are
still moving in any form, you must further tighten it. Ensure that the wall brackets
are screwed firmly to the wall, so that they can in no case tear out when the
awning is installed.
Do not try to secure the wall brackets to loose wall stones or any surfaces that
are not absolutely firm.
Step 6: Install awning
After all three brackets have been mounted properly you can fix the awning. At least two
ladders are required to install the awning in order to obtain the required height. Ensure that
the ladders are firmly resting on the ground so that you cannot fall. Only use ladders that
are suitable for such assembly work.
Insert anchor into wall
WASHER
CROSS SECTION
OF WALL BRACKET
CROSS SECTION
OF WALL