To remove the drill bit, push the chuck cover down all
the way and pull the drill bit out.
1
2
Fig.17
► 1. Drill bit 2. Chuck cover
Chisel angle (when chipping,
scaling or demolishing)
The chisel can be secured at the desired angle. Switch
the action mode changing knob to the O symbol, and
then turn the chisel to your desired angle.
Fig.18
► 1. Action mode changing knob 2. O symbol
Switch the action mode changing knob to the
bol. Try hand-turning the chisel to ensure it is securely
held in place.
2
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth.
Press and hold the lock button, and then insert the
depth gauge into the hex hole. Make sure that the
toothed side of the depth gauge faces the toothed mark-
ing on the hex hole.
4
1
2
Fig.19
► 1. Depth gauge 2. Lock button 3. Hex hole
4. Toothed side 5. Toothed marking
Adjust the depth gauge by moving it back and forth
while pressing the lock button. After the adjustment,
release the lock button to lock the depth gauge.
1
NOTE: Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
Dust collection system
Optional accessory
Installation
sym-
1.
Slide the air duct cap out of the motor housing
while lifting the lock tab up to the unlocked position.
Fig.20
► 1. Air duct cap 2. Lock tab
12 ENGLISH
5
1
2
3