Makita GRH07 Manual De Instrucciones página 24

MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing filter of dust case
Optional accessory
1.
Remove the dust case while pressing down the
latch lever of the dust case.
Fig.56
► 1. Latch lever
2. Lift the lock tab slightly outwards and open the
dust case cover.
2
Fig.57
► 1. Dust case cover 2. Lock tab
3.
case and dust case cover as shown in the figure. Press
the side walls of the filter case inwards, and lift the filter
case up off using the flat-blade screwdriver.
Fig.58
► 1. Flat-blade screwdriver 2. Filter case 3. Dust case cover
4.
figure.
1
Fig.59
► 1. Filter 2. Filter case
5.
case back onto the dust case aligning the guide projec-
tion on the filter case with the groove in the dust case.
1
Fig.60
► 1. Guide projection 2. Groove
6.
the dust case to the dust collection system.
24 ENGLISH
Insert a flat-blade screwdriver in between the filter
1
Push the filter out of the filter case as shown in the
2
1
Replace a new filter in the filter case. Set the filter
2
Close the dust case cover, and then reassemble
2
3
1