Selecting A Location - STACK-ON TD-24-GP-C-S Instrucciones

SELECTING A LOCATION

e safe must mounted to the oor. For optimal
safety and security, the safe should be installed
adjacent to a side wall with minimal space on
either side of the safe, in an isolated, dry and
secure area.
e safe should be at against the wall and oor.
Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
ELECTRICAL OUTLET
e safe has a UL Listed interior electrical outlet
that can be connected to an exterior 110V-15A
power source only.
Install the exterior power cord into the electrical
outlet in the back of the safe.
NOTE: For easy access, install the power cord
before securing the safe to the oor.
SECURING THE SAFE
NOTE: is safe must be secured to the oor.
Use the hardware provided.
NOTE: is safe must be mounted to the oor.
Failure to do so will compromise the safety and
security of the safe.
WARNING: Because this safe is
waterproof it will oat if not secured.
As the water level rises, the safe will
begin to oat and could fall over causing
personal injury.
e safe must be fastened to the oor using the lag
bolts and gasket washers provided with this safe to
insure the waterproof rating. Failure to do so will
void the waterprooof rating.
You must remove the safe from the skid/legs and
place the safe on the oor. Failure to do so will
void the re and waterproof ratings.
Place the safe in the desired location. When your safe
is open, li the carpeting up and locate the mounting
hole bushings. ese bushings are lled with re
resistant caulking which must be drilled out before
mounting the safe to the oor. Use a 3/8" diameter
drill bit to drill out this caulking. Continue to use this
drill to mark the hole location on the oor. Move the
safe away. Drill pilot holes in the oor as follows: For
a wood oor drill 5/16" diameter x 2-1/2" deep pilot
holes. For a masonry oor drill 7/16" diameter x
2-1/2" deep pilot holes for the anchors.
IMPORTANT: When you drill out the re resistant
caulking om the mounting hole you must mount
the safe to the oor using the lag bolts and gasket
washers. Failure to do so will void the re rating
and waterproof rating.
Reposition the safe and secure the safe with the lag
bolts and gasket washers. Replace the carpeting.
3
14
40653-2203