SELECTING A LOCATION
is safe must be mounted into a drawer. For
optimal safety and security, the safe should be
installed in an isolated, dry and secure area.
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
SECURING THE SAFE
NOTE:
is safe must be mounted into a drawer.
Failure to do so will compromise the safety and
security of the safe.
Select an appropriate sized drawer for your safe. Place
the safe in the drawer and try opening and closing the
safe and drawer. Do not a empt to close the drawer
with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe and
drill the pilot holes for the screws. Replace the safe in
the drawer and insert the screws through the mounting
holes and drawer bo om. Secure the bolt by tightening
the Nylock nut on the screws. (Figure 1)
Figure 1
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound turned on.
To turn the sound o , press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.
MAINTENANCE
Do not use glass cleaners or sprays on this safe.
Clean with a damp cloth.
IMPORTANT
Keep keys in a secure place, away from children. Keep this
record of your serial number in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the a ached form.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
4
18
40540-1507