Climbing Technology KIT 12 Manual Del Usuario página 3

The instructions for use of this equipment consist of different sets of instructions:
general instructions, accessory instructions for Kit 12 component and specific in-
struction of the device used (SKR+ or SKR-2). All sets of instructions must be care-
fully read before using the equipment. Attention! This document only contains the
accessory instructions for Kit 12 component.
ACCESSORY INSTRUCTIONS KIT 12.
This note contains the necessary information for a correct use of the following
product/s: component Kit 12. Attention! For the connectors included in these
products, refer to the relative instructions for use.
1) FIELD OF APPLICATION. Kit 12 product is an accessory component and/or
spare parts to be used exclusively with SKR+ or SKR-2 devices: check compatibi-
lity before use (Fig. 1-3). Attention! Kit 12 product, by itself, do not comply with
any regulation and therefore they are not PPE (Personal Protective Equipment).
Attention! Any use other than stated is to be considered prohibited. Attention! For
this product the indications of the standard EN 365 must be respected (general
instructions / paragraph 2.5). Attention! For this product a periodic thorough
inspection is compulsory (general instructions / paragraph 8.)
2) NOMENCLATURE (Fig. 2). A) Connector. B) Positioning device Fix Pro. C) 12
cm webbing (Ref. No FET11012). D) Label.
2.1 - Main materials. Refer to the legend in the general instructions (paragraph
2.4): 3 (connector) / 7-10 (webbing).
3) MARKING. Numbers/letters without caption: refer to the legend in the general
instructions (paragraph 5).
3.1 - General (Fig. 3.1). Indications:1; 4; 7; 8; 30) Pictogram showing the prod-
uct; 31) Warning recommending the user to only use the product in combination
with SKR+ / SKR-2 devices.
3.2 - Traceability (Fig. 2). Indications: T2; T8; T9.
4) COMPATIBILITY. Kit 12 component must be connected to the device (SKR+ o
SKR-2) as indicated in the relevant specific instructions for use. The connectors
included in Kit 12 component can be replaced, if necessary, with any EN 362
oval connector with locking gate and maximum length of 112 mm.
5) REPLACEMENT PARTS / ACCESSORIES. This product is compatible only with
with the spare parts and specific accessories listed below: positioning device Fix
Pro* (Ref. No. 6V82800); 12 cm webbing* (Ref. No FET11012). Attention!
Accessories/spare parts marked with an asterisk (*) by themselves do not consti-
tute PPE. Attention! Before installing an accessory/replacement part, carefully read
and understand the instructions for use of the device on which it will be installed.
Attention! Before use make sure that the accessory/spare part is correctly installed.
Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY
ENGLISH
www.climbingtechnology.com
Member of
IST52-KIT12CT_rev.0 12-21
3/25