Bosch Dremel Versa PC10 Instrucciones De Funcionamiento Y Seguridad página 17

2610054085.qxp_Layout 1 5/28/19 7:21 AM Page 17
Step 2
the tool is turned "OFF" before changing
accessories, changing backing pad, re-
moving splash guard, or servicing your
cordless rotary tool.
▼ ATTACHING SPLASH GUARD
To attach splash guard: line up pins on the
guard with the slots on the tool housing
(Fig. 3). Twist in a counterclockwise direc-
tion until it is snug on the tool. You must
attach the splash guard before attaching
the backing pad.
▼ ATTACHING BACKING PAD
To attach backing pad: align with the
threads of the output shank and finger
tighten the pad in a clockwise direction
(Fig. 3).
▼ ATTACHING ACCESSORIES
Accessories are attached to backing pad
by hook-and-loop system.
To attach: align "loop" side of accessory
to "hook" side of backing pad on the tool
(Fig. 3). Align accessory as close to center
as possible on the backing pad so it spins
concentrically for optimal performance
and ease of use. The accessories will over-
hang the backing pad, which allows the
user to get into corners and tight spaces.
To reduce the risk of
injury, always be sure
Assembly
Pin
Backing
Pad
Loop Side
Accessory
Fig. 3
Slot
Shank
Splash
Guard
Bristle
Brush
17