2610054085.qxp_Layout 1 5/28/19 7:21 AM Page 8
to only charge Dremel Versa. Using Dremel
Versa power adapter to charge other products
may result in tool and property damage and
personal injury.
Dremel. Use of other USB cables may result
in tool and property damage and personal in-
jury.
Charge tool in temperatures above +32 de-
grees F (0 degrees C) and below +113 de-
grees F (45 degrees C). Store tool in
locations where temperatures will not ex-
ceed 122 degrees F (50 degrees C). This is
important to prevent serious damage to the
battery cells.
Do not recharge tool in damp or wet environ-
ment. Do not expose power adapter to rain
or snow. Water entering power adapter may
result in electric shock or fire.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid con-
tact with skin and eyes. The battery liquid is
caustic and could cause chemical burns to tis-
sues. If liquid comes in contact with skin,
wash quickly with soap and water. If the liquid
contacts your eyes, flush them with water for
a minimum of 10 minutes and seek medical at-
tention.
Place tool on flat nonflammable surfaces and
away
from
flammable
recharging. Carpeting and other heat insulat-
ing surfaces block proper air circulation,
which may cause overheating of the power
adapter and tool. If smoke or melting of the
8
Charger Safety Rules
Charge Dremel versa with
a USB cable provided by
materials
when
power adapter or tool is observed, unplug the
charger immediately and do not use the tool
or charger. Contact customer service immedi-
ately.
Make sure that USB cable is located so that
it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
Damaged plug and cable may result in electric
shock or fire.
Disconnect the tool from the power adapter
by pulling the plug rather than the cable. Do
not operate power adapter with damaged
USB cable or plug; have them replaced imme-
diately. Damaged plug or cable may result in
electric shock or fire.
Do not disassemble power adapter or oper-
ate the power adapter if it has received a
sharp blow, been dropped or otherwise dam-
aged in anyway. Incorrect reassembly or dam-
age may result in electric shock or fire.
Before each use, check the power supply,
USB cable and plug. If damage is detected,
do not use the power adapter. Never open
the power adapter yourself, take it to a
Dremel Factory Service Center, or qualified
serviceman only using original spare parts.
Incorrect reassembly may result in electric
shock or fire.
Do not use attachments not recommended
or sold by Dremel. Using attachments not rec-
ommended may result in electric shock or fire.
Unplug tool from power adapter when bat-
tery in tool is fully charged. Tool left plugged
in the power adapter over a long period of