Before You Start; Functions And Settings - Kingfisher 3663602820727 Manual Del Usuario

Use
Utilizare

Before you start

01 To install batteries
1. This instrument requires 1 x 1.5V AAA/LR03 battery (not included).
2. Remove the battery compartment cover.
3. Insert the batteries paying attention to the polarity (+/-) marked on the compartment and batteries.
4. Close the battery compartment cover.
CAUTION!
• ALWAYS turn off the instrument before replacing the batteries.
• ALWAYS remove the batteries if the instrument is not to be used for
extended periods.
• ALWAYS use high quality batteries of the same brand, type and age.
• If the instrument does not work properly, or the low battery icon is displayed,
replace the batteries immediately.
• DO NOT expose the batteries or instrument to extreme temperatures or direct
heat source, as this can cause the batteries to leak.
• If the batteries should leak, remove them using a cloth and dispose of them
according to local regulations. Clean any leaked battery acid avoiding any contact
with skin, eyes & mouth.
• If any contact does occur, rinse affected areas immediately with fresh water and
seek medical advice.

Functions and settings

01 Operation instructions
• Press the MODE button to switch between CLOCK and ALARM.
• The display will return to CLOCK after one minute if no buttons are pressed.
• Press the ADJ button to display the DATE.
• The display will return to CLOCK after 3 seconds if no buttons are pressed.
• Press the MEMORY button to switch between Current, Maximum, & Minimum, Temperature and Humidity readings.
• The display will return to the Current readings after 5 seconds if no buttons are pressed.
• The MAX/MIN readings can be reset by pressing and holding the MEMORY button for 2 seconds, whilst either the MAX or MIN
readings are displayed.
• Switch between Celsius and Fahrenheit by pressing the °C/°F button on the back.
Setting the Time, Date and Alarm
•
• Press the ADJ button to set the correct value.
Utilisation
Uso Utilização
Benutzung
3