3. LIMITATIONS AND WARNINGS
3.A Limitations
This door is intended to close partitions, mainly in interior spaces.
The door is designed for motorized operation. In the event of an emergency or power failure, the door is designed
for manual operation (see section 4.C of this manual).
The cycles established for the door are set out in the following table:
EN
In case the number of yearly work cycles, to which you are going to subject the door, is higher than that indicated
in the table above, more exhaustive maintenance than initially recommended should be carried out. In this case,
please contact the manufacturer to estimate the most appropriate maintenance for these conditions of use.
ATTENTION: Failure to comply with the limitations of the door may cause the machine to break down or
malfunction and may jeopardize the integrity of operators and installations in the vicinity of the machine.
Only use the door when no faults or errors are indicated.
3.B Warnings
•
Monitor the movement of the door and keep people away until it is fully opened or closed.
•
Visually inspect the installation frequently for signs of wear, damage or imbalance; in particular, the canvas,
profiles and attachments. Do not use the door if adjustment or repair is necessary, as this may cause damage.
•
After any failure in the electrical supply, check the correct operation of the installation (the door must open and
close in a completely safe manner) and the control panel. Otherwise the table must be rescheduled. This action
must be performed by a qualified person.
•
Avoid using abrasive products when cleaning the doors.
•
Avoid blows that may cause deformation of the pulley, drawers, guides or mechanisms.
•
Never attach any component to the door that could increase its weight.
•
Never use the door as a lifting device.
•
Never open and close the door with buttons other than those provided, and do not increase or decrease its
speed of movement.
•
The door is not designed or built to pull objects or people.
•
Do not place heavy objects on the door or apply perpendicular force to the door leaf.
32
This user manual must be handed to the customer and must be kept in a safe place throughout the whole period of use!
USE
Industrial
WORK CYCLES PER YEAR
100.000