Kohler K-9025 Manual Del Usuario página 5

Drop-in Installation
Water Resistant
Wall Board
Å
Shim
Å
Å
Stud Wall
Å
Flange
Finished Floor
Front Section Of Wall
5. Install the Finished Wall
- For drop in installations: Install water resistant wallboard with the paperbound edge a minimum of 5/8" (1.6cm)
of the receptor edge. Install desired trim around the unit to conceal the receptor edge.
- For tile in installations: Install water resistant wallboard with the paperbound edge a minimum of 5/8" (1.6cm)
above the receptor deck.
NOTE: To ensure proper fit of the shower door, install the wall material between 3/4" (1.9cm) and 1 1/2" (3.8cm)
thick when measured from the 2x4 studding.
- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal
the joints between the receptor flange and the finished wall material with silicone sealant.
6. Finish Installation
- Seal around the valving and outlets with silicone sealant or plumbers putty.
- Install grab bars or towel bars to the backing in the stud wall (previously installed). Follow all manufacturer's
instructions.
- Install the shower door according to the manufacturer's instructions.
Kohler Co.
Finished Wall
Apply Silicone
Sealant Here
5/8" (1.6cm)
Tile-In Installation
Water Resistant
Wall Board
Å
Å
Apply Silicone
Shim Sealant Here
Å
Stud Wall
Î Î Î
Î Î Î
Flange
Î Î Î
Î Î Î
Sub-Floor
Front Section Of Wall
5
Finished Wall
5/8" (1.6cm)
1009404-2-
A