Measuring Ac Voltage; Measuring Dc Voltage - Metrix MX 350 Manual De Instrucciones

Before changing the batteries, set the switch to
"OFF", disconnect the measuring leads and
remove the clamp from the circuit measured.
Start the clamp-on multimeter; make sure that all

segments are displayed.
Check that on Continuity position, and without any

input the meter display OL.
Take out both cords and short circuit, the beeper

should sound.
Turn the rotary switch on V and check a known

voltage (for example a battery) and make sure voltage is
correct.
When all the steps above are correct, you can start to use
the meter.
1.
2.
3.
4.
In the presence of a hazardous voltage (>30V
AC) the
1.

Measuring AC voltage

Set the switch to
Connect the red test lead to the
terminal and the black test lead to the
input terminal.
Apply the probe tips on the points where the
AC voltage is to be measured.
Read the result on the display unit
signal blinks on the screen.

Measuring DC voltage

Set the switch to
input
21