Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Align holes on throttle
brackets 1 and 2. Insert
M5x22 screw through
lower hole.
Insert spacer over screw
thread on opposite side
against throttle bracket 2.
Insert (3) 8mm washers
over spacer.
Insert throttle lever over
spacer.
Insert 5mm washer over
thread.
Secure in place using M5
lock nut.
Insert M6 nut onto
threaded end of bowden
cable.
Insert bowden cable
through hole on throttle
bracket 2.
Secure in place with M6
nut.
Part Description
Throttle Bracket 1
Throttle Bracket 2
Throttle Lever
8mm Washers
5mm Washer
M5 Lock Nut
Spacer
M5x22 Screw
M6 Nut
Bowden Cable
M6 Nut
Illustrations
Tools
Screwdriver
8mm Wrench
Page #
7
Publicidad
