Application; Installation; Operation; Important - Schulz Air Plus 12V Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. APPLICATION

This product is exclusively for Hobby /Domestic use.
The AirPlus 12V Air Compressor may be used for infl ation of:
balls;
fl oating devices;
car, motorcycle, and bicycle tires;
fl ashlight (except for model Air Plus 12V Duo);
other vehicles or small volume infl atable objects.

6. INSTALLATION

Only install the compressor in power sockets of cigarette lighters with direct current 12 volt voltage;
Check if your vehicle needs the ignition to be turned on for electrical equipment use;
Do not use the compressor with the vehicle motor working, and, above all, do not use it in the presence of children and
animals;
For circuit protection, use a 10A or 15A (Air Plus 12V Duo) fuse;
For circuit protection, use a 2A/250V into AC voltage (for Model Air Plus 12V Duo).

7. OPERATION

IMPORTANT

the time needed for cooling.
Compressor Air Plus 12V Schulz - To infl ate tires:
1.
Check if the tire valve is in a position you can reach. It should be placed preferably close to the ground. That will make the
connection easy and prevent the valve from moving to the inside of the wheel;
2.
Connect the plug to the cigarette lighter or power outlet, if available (Figure 7.1);
3.
Connect the hose tip to the tire valve and lock it (Figures 7.2 and 7.3);
4.
Place the switch in the "AIR" position (Figure 7.4);
5.
When the desired pressure of the tire is reached, turn off the switch (Figure 4) and disconnect the plug from the power
outlet.
• Flashlight Air Plus 12V: You just have to place the switch in the "light" position (Figure 7.4).
Compressor Air Plus 12V Digital Schulz - To infl ate tires:
1.
Check if the tire valve is in position you can reach. It should be placed preferably close to the ground. That will make the
connection easy and prevent the valve from moving to the inside of the wheel;
2.
Connect the plug to the cigarette lighter or power outlet, if available (Figure 7.1);
3.
Connect the hose tip to the tire valve and lock it (Figures 7.2 and 7.3);
4.
Check the pressure in the tire in the compressor display (Figure 7.7);
5.
If the pressure is below the desired, press the (+) button in PRESET in the compressor panel to set the desired pressure.
(Figure 7.7);
6.
Flip the compressor switch to the "On" position (Figure 7.5);
7.
The compressor will turn off when it reaches the pressure;
8.
Flip the switch to the "Off" position (Figure 7.5), disconnect the hose tip and the plug from the power outlet.
Important: The compressor has a (+) button to increase the pressure and a (-) button to decrease the pressure.
Besides, it has a reset button that, when pressed for over 5 seconds, clears the pressure setting. In the same reset button, you
can choose the pressure scale (Psi/Bar/kPa).
When the maximum pressure reached for calibration is over 40 PSI, or the usage time is longer
than 10 minutes, perform the operation in stages, placing the compressor in a ventilated place by
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Air plus 12v digitalAir plus 12v duo

Tabla de contenido