Denver TC-28 Manual De Instrucciones página 8

Tuning to an FM station
1. In FM mode, press the FM SCAN button to initialize scan. When an
available radio station is tuned to, the scan stops.
2. Press the Next/TUN+ or Previous/TUN- button to fine tune each frequency
in 0.05 MHz steps, if necessary.
Storing an FM station
Your boom box can store up to 10 FM radio stations in its preset memories for
instant access to your favorite stations.
1. Tune the boom box to the FM radio station that you wish to preset.
2. Press and hold the PRESET button for approximately 2 seconds until 'P01'
is displayed.
3. Press the PRESET button to select a preset number (1-10) you would like to
store the radio station to.
4. Press and hold the PRESET button. 'P XX stored' is displayed, where 'X' is
the number of the preset (1-10).
Note: If there is already an existing FM station stored under a preset, the
newly stored station overwrites the old one.
Selecting a preset FM station
1. In FM mode, press the PRESET button to select a preset station number (1-
10) you would like to listen to.
2. Press and hold the PRESET button to confirm selection. The preset station
begins to broadcast.
Note: If no FM station has been stored under a preset number, 'Preset
Empty' is displayed, and then the boom box reverts to the previously
selected radio station after a few seconds.
CD Mode
Check that your Boom box is in CD mode. To enter CD mode, press repeatedly
the /SOURCE button until CD mode is displayed. The display shows
5