Inserting Batteries - Phottix Odin TTL Manual De Instrucciones

7. Strato and Strato II Multi transmitters will not
trigger Odin receivers.
8. Phottix Odin for Nikon TCUs will not trigger
Odin for Canon Receivers.
9. Using the Odin TCU in HSS mode may cause
issues with ash sync when using Strato and
Strato II Multi receivers.
LED functions
The LED on the TCU and receiver units will
turn green when the camera is focusing and
red when a photo is being taken.
Using the LCD Backlight
Pressing any button on the TCU will turn on the
LCD Backlight for approximately 10 seconds. If
no further buttons on the TCU are pressed the
light will go o .
6
Using the Modeling Light Button
Pressing the Modeling Light Button on the TCU
will cause all ashes attached to Odin receivers
to ash for one second. This is useful as a
preview of lighting set-ups or for assist-focus.

Inserting batteries

1. Press the battery cover in while pushing it
away from the Phottix Odin TCU or receiver.
The battery cover will slide open.
2. Remove the battery cover.
3. Insert AA batteries as shown.
4. Replace the battery cover and push back into
the locked position.
5. When the battery power icon on the TCU
shows low battery levels please change the
batteries.