Inserting Batteries; Battery Level Indicator - Phottix Strato TTL Manual De Instrucciones

5. Using the Strato TTL Transmitter in HSS
mode may cause issues with flash sync when
using Strato and Strato II Multi receivers or
Atlas II Transceivers (in RX mode).

Inserting batteries

1. Press the battery cover in while pushing
it away from the Strato TTL transmitter or
receiver. The battery cover will snap open and
slide away from the device.
2. Remove the battery cover from the Strato
TTL.
3. Insert AA batteries.
4. Replace the battery cover and push back
into the locked position.
EN

Battery Level Indicator

When the battery voltage is higher than 2.4V,
the battery level indicator icon will display
four bars
depleted the bars displayed in the battery
level indicator icon will disappear. When the
batteries are exhausted the battery level
indicator will display an empty with battery
icon .
LCD Backlight on the transmitter
Pressing any button on the transmitter
w i l l i l l u m i n a t e t h e LC D B a c k l i g h t fo r
approximately 10 seconds. If no buttons on
the transmitter are pressed, the backlight will
go off.
INSTRUCTION MANUAL
. As power in the batteries is
5