Laevo FLEX V3.0 Guía Rápida página 4

4
Quick Guide
a
Laevo FLEX V3.0
Personal protective back support for workers
This Quick Guide is a summary of the
complete User Manual. For the complete
user manual, including detailed fitting
procedure, go to
www.laevo-exoskeletons.com/flex-training
Introduction
These instructions explain how to use your equipment
correctly. Only certain uses are described. Find additional
information and updates online at
www.laevo-exoskeletons.com.
You must obey all warnings and instructions. Contact
Laevo if you are not sure that you understand the
instructions.
Read carefully before use.
Obey the safety instructions.
If you are not the only user, make sure that all users know
how to use the product correctly and safely.
Main parts (see image A)
1. Vest frame
2. Front vest
3. Hip frame
4. Torso structures
Product information (see image B)
The product is intended to be used as personal protective
equipment (PPE) to prevent injury of back muscles and
bones caused by repetitive movements, for example,
when you bend forward, hold this posture and return
upright, squat, or lift.
Do not run, climb, work at heights or drive any vehicle,
for example, a forklift. Do not use the FLEX to lift heavier
loads then permitted by law or company directives.
General safety instructions
WARNING!
6
Identifies possible serious injury.
•
Expose chest before CPR: Unzip the two halves of the
front vest. Push the halves outward. Release the buckle
of the front vest.
• Never use the FLEX when the vest frame is damaged
or bent. Check the vest frame for damage regularly.
• Do not put your fingers near pivot points while you
bend or carry the FLEX.
•
Do not let other people put their fingers near the FLEX
while it is used (except during setup).
•
Keep the FLEX away from children and pets.
•
Do not use the FLEX directly against the skin.
• Do not use the FLEX if it is damaged.
• Do not use the FLEX when a sudden hand or head
movement could cause injury to you or someone else.
5. Smart joint
6. Front belt
7. Leg pads
• Be careful not to accidentally push buttons, for
example, by bumping. Do not push buttons on the
FLEX while in use.
•
Do not use out-of-date or overloaded torso structures.
In general, the FLEX should not be used after the torso
structures are more than three years old or have been
used for 250,000 cycles.
• Put on appropriate clothing. Do not put on clothing
or accessories that have loose ends, for example,
necklaces or scarves. Do not keep hard objects in your
clothing or pockets under the FLEX. If something
becomes caught in the FLEX, move slowly to release
and remove it. If you have long hair, put your hair in a
ponytail or bun.
•
Do not let anyone else put their hands on the FLEX
while you use it.
• Do not make changes to parts of the FLEX.
Preparation (see image C)
Before you use the FLEX, make sure that your order is
complete and that you received the correct sizing parts.
Additional parts may be included. This manual shows the
parts you should receive, at a minimum.
Register the torso structures at
www.laevo-exoskeletons.com/register
for specific advice on when to replace the
torso structures.
Table: Sizing parts
XS Extra small
S Small
M Medium
L Large
XL Extra large
Table: Actuator Springs
UL Ultra light
L Light
M Medium
S Strong
US Ultra strong
orange
yellow
red
green
blue
orange
yellow
red
green
blue