Zycoo SQ10 Guía De Instalación Rápida página 8

1
Use an 8 mm drill to drill 4 mounting holes on the wall with 99mm (H) x 38.3mm (W)
spacing. Each hole should be able to fit the M6*25mm anchor.
2
Push the 4 anchors into each mounting hole with a rubber hammer.
3 Knock out the necessary hole guard(s) and pass the network cable through.
4 Place the rear enclosure to the mounting holes, perfect the box position, and fix the
box with the KA4*25 mm screws. Then connect the network cable to the RJ45 connector.
If PoE cable is not used, please connect the power cable to the DC socket through
5
the net coil or the rear enclosure hole.
If there are any buttons, relays, and/or other devices that need to be used. Please
6
connect them to the phoenix terminal of the J2 connector through the net coil or the rear
enclosure hole.
7 Install the front panel onto the rear panel box and tighten with the M4*25mm screws
using a screwdriver.
Installation method -2
Hook Installation
3
4
05
1
2