Side Brush - Mi Vacuum-Mop 2 STYTJ03ZHM Manual De Usuario

· If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly pull on
it, as this could damage the brush.
· It is recommended to clean the brush weekly and replaced every 6 to 12 months.
Omnidirectional Wheel

Side Brush

* Monthly cleaning is recommended
Wheel
Axle
Note:
It is recommended to clean the side brush monthly and replace every 3 to 6 months.
15
* Clean it as needed
1. Flip the vacuum-mop over and pull out the omnidirectional wheel.
2. Remove hair, dirt, and other debris from the wheel and axle.
3. Reinsert the wheel and press it firmly back into place.Notes:
· A small screwdriver or other pry tool can be used to gently pop out and remove the wheel.
· The wheel can be cleaned with water and reinstalled after drying.
1. Flip the vacuum-mop over, then gently pull out the side brush as
shown in the diagram below to clean it.
2. Reinstall the side brush.
Use a soft cloth to clean all senors and chraging contacts in the vacuum-mop:
Sensors and Charging Contacts
bottom.
· The charging contacts on the bottom.
· The four cliff
sensors on the