Updating The Firmware; Restoring Factory Settings - Mi Vacuum-Mop 2 STYTJ03ZHM Manual De Usuario

Remove the pad from the water tank before cleaning it, and make sure dirty
water does not flow back into the water outlet to avoid clogging. Do not press
too hard on the mop pad, as this can hinder its performance. Pad should be
cleaned before each use.
Note:
It is recommended to change the mop pad every 3 to 6 months.
Battery
The vacuum-mop contains a high-performance lithium-ion battery pack.
Please ensure that it remains well-charged during daily use to maintain
optimal battery performance.
Note:
If the vacuum-mop is not used for an extended period, turn it off and put it away.
To prevent damage from over-discharging, the vacuum-mop should be recharged at least
once every three months.
Charging Dock
Clean the contacts of the charging dock with a soft cloth.
21

Updating the Firmware

You can update the firmware via the app. Before updating, make sure the
vacuum-mop is on the charging dock and has at least 15% battery left.
Restarting the Vacuum-mop
If the vacuum-mop stops responding or cannot be turned off, press and hold
down the button for 10 seconds to forcefully turn it off. Then press and
hold the button for 3 seconds to turn the vacuum-mop on.

Restoring Factory Settings

If the vacuum-mop does not function properly after being restarted, use a
pin to press the reset button until you hear a voice saying "Restoring factory
settings". This will reset the vacuum-mop to its original factory