What To Do Before Calling For Authorized Service - EAS ELECTRIC EMR1092DS2 Manual De Instrucciones

WHAT TO DO BEFORE CALLING FOR AUTHORIZED SERVICE

Failure
If the cooler does
not operate (No
noise or just the
fan noise)
Internal
temperature of
the appliance is
high
Internal
temperature of your
appliance is very low
Lamps of your
cooler does not
illuminate or only
one lamp illumi-
nates.
Possible Solution
It may be caused by
the thermostat. It
may be unplugged.
Fuse may be blown
or faulty. Condenser
fins may be dirty or
clogged.
Ambient
temperature is very
high or thermostat
setting is incorrect.
Rear part is very
close to the wall,
ventilation blinds
are blocked or its
front is covered. It
may be exposed to
excessive external
wind. Condenser
fins are very dirty
Wrong internal
thermostat
setting
Lamps are turned
off. Lamp has burnt
out or the starter is
faulty.
24
Result
It shall operate again
when it reaches the
proper temperature.
Plug it correctly.
Consult an EAS
Electric authorized
service or a qualified
electrician.
Take your cooler to
a place where
ambient
temperature is
lower. Bring it to
specified clearance.
Clean the front of
the ventilation
blinds. Prevent
wind. Clean the
condenser fins.
Reset the
thermostat.
Turn the lamps on.
Replace the faulty
part.