Lorex LNZ44P4 Serie Manual De Instrucciones página 16

4 Installation
5. Ensure that the cable notch on the dome camera base is aligned with the cable notch on the
wall mounting bracket. Align the 3 mounting holes on the dome camera base with the 3 cor-
responding mounting holes on the wall mounting bracket.
2
1: Cable Notch
2: Mounting Holes
NOTE
The mounting holes (3x) on the dome camera base will align with the corresponding mounting holes on the
wall mount.
6. Use the Hex Bolt M4x10 (x3) screws included with the wall mounting bracket kit to secure
the position of the dome camera base.
7. Holding the flat side of the back plate against the mounting surface, mark holes for the
mounting screws ST4 (x4) and the camera cable. Remove the back plate and drill where
marked.
NOTE
You do not need to mark holes for the camera cable if you plan to run it along the wall / ceiling.
1: Mounting screw ST4 (x4) holes, 2: Camera cable hole
8. Attach the back plate to the mounting surface using the mounting screws ST4 (x4) included
with the wall mounting bracket kit.
NOTE
Use the drywall anchors included with the wall mounting bracket kit if installing on a drywall surface.
#LX400075; r. 4.0/58710/58717; en-US
1
10