Resetting The Camera - Lorex LNZ44P4 Serie Manual De Instrucciones

10

Resetting the Camera

The camera features a hard reset button that is used to reset all camera settings back to the de-
fault values. This is useful in case you want to revert camera image settings back to the default
values.
To reset the camera:
1. Connect the camera as detailed in 3 Connecting the Camera. Make sure the camera is pow-
ered on.
2. Use the Allen key included with the camera mounting kit to loosen the dome camera cover
screws (x3). Remove the dome camera cover.
3. Press and hold the reset button below the camera module for at least 10 seconds to reset the
camera to default settings.
1. Reset Button
NOTE
• It may take few minutes for the camera image to reappear on the screen.
• This camera does not support micro SD card recording.
#LX400075; r. 4.0/58710/58717; en-US 25