Remote Control; F- Maintenance - SCS Sentinel prim' OneGate 3 Manual Del Usuario

Remote control

Channels
Frequency
Maximum transmitted power
Power supply
Security
Racks
Racks
Material
Blinker
Bulb
Power cable
Bulb connection
Screws
Power supply
Operating temperature
Dimensions
Photocells (option : Ref. AAM0036)
Detection Method
Sensing Range
Input Voltage
Response Time
Operation Indicator
Dimensions
Output Method

F- MAINTENANCE

F- MAINTENANCE
Conduct the following operations at least every 6 months. If in high intensity of use,
shorten the period in between.
Disconnect the power supply:
(1) Clean and lubricate the screws, the pins, and the hinge with grease.
(2) Check the fastening points are properly tightened.
(3) Make the wire connection are in good condition.
Connect the power supply:
(1) Check the power adjustments.
(2) Check the function of the manual release.
(3) Check the function of photocells or other safety device.
4
433.92 MHz
< 1mW
2 batteries lithium CR2016 included
rolling code technology
12 x 34 cm
nylon with steel insert
15 LED
2 x 1 mm² (not included)
Polarized
included
12 V DC
-20°C~+50°C
50 x 70 x 70 mm
infrared beam
10 m max
12~24V AC/DC
< 100ms
RX : Red LED On (beam broken) / Off (beam aligned)
TX : Red LED On
63 x 63 x 30 mm
relay output
EN
35