Castelgarden XK 140 HD Guia De Instalacion página 14

All manuals and user guides at all-guides.com
EN
1 GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
You must read these instructions and
the accompanying pamphlet "SAFETY
INSTRUCTIONS" carefully, before the
assembly begin.
2 ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures in this instruction
have been carried out..
2.1 ACCESSORIES BAG
The machine is supplied with a plastic bag contain-
ing components which shall be used during the as-
sembly. The bag contains (fig. 1):
Pos. No. Designation
B 2 Key
C 1 Tension pin
D 1 Shim washer
E 1 Shim washer
F 2 Shoulder washer
G 2 Screw
H 2 Screw knob
I 4 Washer
J 1 Drawing plate
K 4 Screw
L 2 Nut
M 2 Screw for battery
N 2 Nut for battery
2.2 ENGINE CASING
To fill with fuel and to inspect and maintain the en-
gine and battery, open the engine casing.
The engine must not be running when
the casing is opened.
Opening:
1. Raise the seat lock (fig. 2) and fold the seat for-
wards.
2. Pull up the rubber strap at the front edge of the
casing (fig. 3).
3. Grasp the front edge of the engine casing and
fold up the casing (fig. 4).
Close in the reverse order.
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
14
ENGLISH
2.3 BATTERY
The battery is a valve-regulated battery with 12 V
nominal voltage. The battery fluid does not need to
and cannot be checked or topped up. The only
maintenance that is required is charging, for exam-
ple after extended storage.
After charging the battery must be stored in a cool
place.
2.3.1 Charging with the engine
Dimension
The battery can be charged using the engine's gen-
erator as follows:
6 x 36
1. Install the battery in the machine as shown be-
16 x 38 x 0.5
16 x 38 x 1.0
2. Place the machine outdoors or install an extrac-
8 x 20
3. Start the engine according to the instructions in
8.4 x 24 x 1.5
4. Allow the engine to run continuously for 45
8 x 20
5. Stop the engine. The battery will now be fully
2.3.2 Charging using battery charger
When charging using a battery charger, a battery
charger with constant voltage must be used.
Contact your dealer to purchase a battery charger
with constant voltage.
The battery can be damaged if a standard type bat-
tery charger is used.
Do not short circuit the battery's termi-
nals. Sparks occur which can result in
fire. Do not wear metal jewellery which
can come into contact with the battery
terminals.
In the event of damage to the battery
casing, cover, terminals or damage to
the strip covering the valves, the bat-
tery should be replaced.
The battery must be fully charged be-
fore being used for the first time. The
battery must always be stored fully
charged. If the battery is stored while
discharged, serious damage will occur.
low.
tion device for the exhaust fumes.
the user guide.
minutes.
charged.