Tool Specific Safety Information; Greenlee Contact Information - Greenlee HDE TAG-200X Manual De Instrucciones

Tool Specific Safety Information

Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information for
avoiding hazards and unsafe practices related to the
use of this tool. Observe all the safety information
provided in this manual.
Before operating this tool, read and understand:
• This operator's manual
• The instructions for any other equipment or
material used with this tool
• Markings on the tool
• Required worksite safety procedures
Failure to follow all instructions and warnings may
result in serious injury or death.
• Only a person trained in working around and
on high voltage electric systems should use
this tool. The voltages these instruments operate
around are to be considered live and dangerous
and are lethal. Severe injury or death can occur if
improperly used.
• Always follow proper high voltage procedures,
including use of personal protective equipment,
when working near or around high voltage
equipment or conductors.
• Always use hot sticks when using this tool.
Follow rigorous hot stick work practices to reduce
the risk of injury or death from electric shock or arc
flash.
• Do not touch any part of the detector while it is
in contact with high voltage. The tool should be
considered as at the same voltage as the conductor
under test. Maintain proper high voltage work
clearances.
• Do not let familiarity gained from frequent use
of these tools allow you to become complacent
and ignore tool and work site safety principles.
A careless action can cause severe injury or death
within a fraction of a second.
• Use this tool for the manufacturer's intended
purpose only. Use other than what is instructed in
this manual could result in a hazardous situation.
4
• Use the correct accessories for your application.
Use of the wrong or underrated accessories
increases the risk of injury and tool damage.
• Stay alert, watch what you are doing and use
common sense when using this tool. Do not
use tool while you are tired or under the influence
of drugs, alcohol or medication. A moment of
inattention could result in serious injury or death.
• Do not allow another high voltage conductor,
or grounded point to contact the tool housing
during use. Keep the housing clear of all
conductors. Always maintain proper high voltage
work clearances.
• Do not use the detector at voltages outside
of its designed range. Testing outside of the
specified range will result in a false reading or
no reading at all and could lead to a hazardous
situation. Consult the product label for the specific
ranges for the unit supplied.
• Confirm proper operation before and after each
use to reduce the risk of injury due to false
readings. False readings could lead to a hazardous
situation and increases the risk of severe injury or
death.
• Do not overreach. Always keep proper footing and
balance, this enables better control of the tool in
unexpected situations.
• Keep tools clean and in good condition. A dirty
or damaged tool increases the risk of false readings
and increases the risk of electrical shock.

Greenlee Contact Information

If you have any questions, need to arrange service or
purchase parts or accessories for this Greenlee product:
Contact your local Greenlee distributor or Greenlee's
Customer Service Center.
Additional copies of this manual are available for
download at www.greenlee.com
Greenlee Customer Service
USA: 1-800-435-0786 | Canada: 800-435-0786
International: 1-815-397-7070
GRNCustomerService@emerson.com
Shipping address:
Greenlee Factory Service Center
4411 Boeing Dr., Rockford, IL 61109
© 2021 Greenlee Tools, Inc.
TAG-200X & TAG-200XMR
52093091 REV 00