DeWalt DW925 Manual Del Usuario página 26

E N G L I S H
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework
and wiring.
• Apply only a gentle pressure to the tool.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
• To minimise stalling on break-through,
progressively reduce the drill point
pressure towards the end of the
operation.
• Keep the motor running when pulling the
bit back out of a drilled hole. This will
help prevent jamming.
Prior to operation:
• Make sure your battery pack is (fully) charged.
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
• Select forward or reverse rotation.
Switching on and off (fig. A & D)
• To run the tool, press the variable speed switch (1).
The pressure exerted on the variable speed switch
determines the tool speed.
• To stop the tool, release the switch.
• To lock the tool in off position, move the forward/
reverse slider (2) to the central position.
The drill is equipped with a brake to stop
the tool as soon as the variable speed
switch is fully released.
Screwdriving (fig. A)
• Select forward or reverse rotation using the
slider (2).
• Set the collar (4) to position 1 and begin
screwdriving (low torque).
• If the clutch ratchets too soon, adjust the collar
to increase the torque as required.
Drilling (fig. A)
• Select the drilling mode using the collar (4).
26
All manuals and user guides at all-guides.com
Drilling in metal
• Use a cutting lubricant when drilling metals.
Drilling in wood
• Holes in wood can be made with the same twist
• For larger holes use Auger bits.
• Use a block of wood to back up workpieces that
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
• Remove the battery pack before cleaning your
• Keep the ventilation slots clear and regularly
Environment
Rechargeable battery pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
The exceptions are cast iron and brass which
should be drilled dry.
drills used for metal. These bits may overheat
unless pulled out frequently to clear chips from
the flutes.
may splinter.
WALT Power Tool has been designed to
E
with a soft cloth.
Power Tool.
clean the housing with a soft cloth.