Denon AVR-1803 Instrucciones De Operación página 13

4
Use the (left) and
to the OPTICAL input 3 (OPT 3) terminal.
15 OPT3 TAPE
• Select "OFF" if nothing is connected.
Press the ENTER or
Component Video input (VIDEO1) setting.
NOTE:
• PHONO, TUNER and V. AUX cannot be selected.
Setting the Video In Assignment
Input the type of components connected to the component video input terminals.
1
Use the (left) and
to the COMPONENT VIDEO 1 input (VIDEO1) terminal.
16 VIDEO1 DVD
• Select "OFF" if nothing is connected.
Press the ENTER or
component video input 2 (VIDEO2) setting.
2
Use the (left) and
to the COMPONENT VIDEO 2 input (VIDEO2) terminal.
17 VIDEO2 TV
• Select "OFF" if nothing is connected.
Press the ENTER or
Auto Surround Mode setting.
(right) buttons to assign the input function connected
(Initial)
CD DVD TV VCR1 VCR2 TAPE
(left) button (right) button
(down) button to enter the setting and switch the
(right) buttons to assign the input function connected
(Initial)
DVD TV VCR1 VCR2 V.AUX OFF
(left) button (right) button
(down) button to enter the setting and switch the
(right) buttons to assign the input function connected
(Initial)
DVD TV VCR1 VCR2 V.AUX OFF
(left) button (right) button
(down) button to enter the setting and switch the
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the
memory. At next time it the same signal inputs, the memorized surround mode is automatically selected and
the signal is played.
OFF
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
Use the
Press the ENTER or
Setting the Ext. In SW Level
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1
Use the
Level playback.
Press the ENTER or
from the beginning.
After setting up the system
1 Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings
again unless other components or speakers are connected to or the speaker layout is changed.
Default Auto Surround Mode
STEREO
Dolby PLII Cinema
Dolby or DTS Surround
(left) and (right) buttons to select the Auto Surround mode.
(Initial)
OFF
18 AUTOSURR. ON
(left) button (right) button
(down) button to switch the Ext. In SW Level setting.
(left) and (right) buttons to select the Ext. In Subwoofer channel
+00 +05
19 EXT.IN SW +15
(left) button
(down) button if you want to start the settings over
ENGLISH
ON
(Initial)
+10 +15
(right) button
13