Control Panel - Danby DDR050BCWDB-ME-6 Manual Del Propietário

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Power button:
• Press to turn the dehumidifi er on or off.
• Press and hold for 3 seconds to activate the wireless connection.
2. Humidity adjust buttons: The humidity level can be set within a range of 35% to 85% relative humidity
in 5% increments. For drier air, set to a lower percentage value. For more damp air, set a higher
percentage value.
3. Fan button:
• Press to select normal or high fan speed.
• After 250 hours of operation, the fi lter light indicator will illuminate on the display. Clean the fi lter
and then press and hold the fan button for 3 seconds to reset the fi lter indicator.
4. Mode button: Press the mode button to select the desired mode.
• Set mode: the humidity level and fan speed can be set manually by the user.
• Continuous mode: the dehumidifi er will run continuously. The humidity level cannot be adjusted.
The fan speed can be adjusted.
• Max mode: the dehumidifi er will run continuously. The humidity level cannot be adjusted. The fan
speed will be set to high and cannot be adjusted.
5. Fill level button:
• Press the fi ll level button to choose the bucket capacity: 1, 2, 3 or 4.
6. Timer button: Press to set the timer.
7. Display:
• Shows the set humidity level between 35% to 85% relative humidity while setting, then shows the
ambient humidity in a range of 30% to 90% relative humidity with an accuracy of ±5%.
• Displays the timer settings.
• Shows all error codes.
A. Indicator will illuminate when the wireless connection is active.
B. Indicator will illuminate when the fi lter needs to be cleaned.
C. Indicator will illuminate when the dehumidifi er is being used without the bucket installed.
1
2 3 4 5
5
7
A
6
B
C