Kaco Bending-box on blueplanet 87.0-165TL3 Guía Rápida página 5

Connect PID regeneration
↻ PID cable is ready for use.
1 Unfasten the PID cable fittings on the component. [
W_20]
2 Pass PID cable via cable fittings on the component into
the connection area of the inverter.
3 Position PID cable correctly to the connection point on
the DC filter and secure with cable tie and connect
[See PID kit installation instructions]
4 Align PID cable at zero potential and secure cables with
cable fittings. [ W_20 /
» Connection prepared for PID box.
Bending-box S; XL Version
3
1,5 Nm ]
Fig. 6: Guide PID cable through component
1
2
3
2
1
Cable fitting
PID cable
Spring-type connection terminal
Page 5